E-flite UMX Sbach 342 BNF User Manual download pdf (Page 11)

Service of Power Components

Disassembly

CAUTION: DO NOT handle propeller parts

while the ﬂ ight battery is connected. Personal

injury could result.

Propeller

1. Remove battery hatch by gripping the

front of hatch, then pulling it up and

away from the fuselage.

2. Remove spinner (A) from the propeller (B).

Note: Since the propeller and spinner are

glued together, glue residue will need to be

cleaned from the spinner or propeller when

these parts are used again.

3. Carefully remove screw (C) and propeller

(B) from motor shaft (D).

Note: A propeller spacer is installed on the

motor shaft. Take care to not lose the spacer; it

is needed to correctly install the propeller.

Motor and Firewall

1. Remove 2 screws (E), firewall (F) and

motor (G) from the fuselage motor

mount (H).

Note: The motor magnet will attract screws

to the motor.

2. Remove top screw (I) from the firewall (F)

and motor (G).

3. Disconnect motor wire connector from

ESC/receiver connector.

Assembly

Motor and Firewall

1. Connect motor wire connector to the ESC/

receiver connector so wire colors align.

2. Install motor in firewall using a screw put in

the top of the firewall.

3. Attach firewall to fuselage motor mount using

2 screws.

Propeller

1. Install propeller on motor shaft using a screw.

Note: Numbers on the propeller must face out

from fuselage for correct propeller operation.

2. Install spinner on propeller using foam-

compatible CA.

3. Put foam battery hatch on the fuselage and

slide it back to fully engage the fuselage.

When the fuselage must be opened for access to

servos or receiver, cut tape or decals to open the

canopy hatch.

Note: Removing tape or decals will remove paint

from the fuselage.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments

E-flite UMX Sbach 342 BNF User Manual Page 11

Comments to this Manuals

Related products and manuals for Air equipment E-flite UMX Sbach 342 BNF