E-flite Super Cub 25e ARF User Manual download pdf (Page 38)

38 E-flite Super Cub 25e ARF Assembly Manual

 7. Repeat steps 1 through 3 to prepare and install

the navigation light. When installing the navigation

lights, the red will be on the left, and the green will

be on the right. Leave the light extended out so it is

visible in the navigation light cover when the cover

is installed.

 8. Install the navigation light cover using canopy

glue. The fit should be tight, so tape will not be

needed to hold the cover in position.

 9. Use the template on page 45 to make the cover

for the navigation light lens using adhesive-backed

Ultracote trim sheet.

 10. Repeat steps 1 through 3, and 7 through 9 to

install the remaining navigation light.

Accessory Installation

Required Parts

Wing panel (right and left)

Landing light cover Navigation light cover (2)

Required Tools and Adhesives

Canopy glue

 1. Use canopy glue to glue the landing light cover

to the wing. Use low-tack tape to hold the cover in

position until the glue fully cures.

 2. Install the navigation light cover using canopy

glue. The fit should be tight, so tape will not be

needed to hold the cover in position.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

No comments

E-flite Super Cub 25e ARF User Manual Page 38