E-flite Super Cub 25e ARF User Manual download pdf (Page 29)

29E-flite Super Cub 25e ARF Assembly Manual

 8. Use a pin vise and 5/64-inch (2mm) drill bit to

enlarge the hole in the servo horn. Enlarge the hole

that is 1/2-inch (13mm) from the center of the horn

as shown. Use side cutters to remove any unused

arms so they don’t interfere with the operation of

the servo.

 9. Pass the Z-bend in the pushrod through the

hole enlarged in the previous step. With the

servo centered, attach the servo horn to the servo

using the screw provided with the servo and a #1

Phillips screwdriver.

 10. Repeat steps 6 through 9 to install the elevator

pushrod. Make sure to install a clevis for both

elevator control horns

Drawing not to scale

Elevator

Attach clevis

to the

outer hole

 11. With the radio system on and the rudder and

elevator servos centered, check that the control

surfaces are aligned with the fixed surfaces. Use a

ruler between the two surfaces. Adjust the clevis as

necessary to align the surfaces. Once aligned, slide

the silicone tubing over the forks of the clevis to

prevent them from opening accidentally. Check both

elevator and the rudder at this time.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

No comments

E-flite Super Cub 25e ARF User Manual Page 29