E-flite Super Cub 25e ARF User Manual download pdf (Page 27)

27E-flite Super Cub 25e ARF Assembly Manual

 4. Use side cutters to remove the flat portion of the

springs. Use pliers to bend the outermost coil at

each end 90 degrees outward to form a hook.

 5. Install the spring between the ruder tiller arm and

the steering tiller arm, attaching it to the center hole

in the steering arm.

 6. Repeat steps 4 and 5 to install the remaining tail

wheel spring.

Rudder and Elevator

Servo and Linkage Installation

Required Parts

Fuselage assembly Servo with hardware (2)

Rudder pushrod Elevator pushrod

Nylon clevis (3) Safety tubing (3)

Transmitter Receiver

Receiver battery

Required Tools and Adhesives

Thin CA Phillips screwdriver: #1

Pin vise Drill bit: 5/64-inch (2mm)

Ruler

 1. Remove the tape holding the servo hatch cover

on the fuselage. Set the cover aside. You may need

to use a covering iron to reseal the covering to the

fuselage if the tape lifts the covering.

 2. Use a #1 Phillips screwdriver to thread a servo

mounting screw into each of the holes to cut threads

in the surrounding wood. Remove the screw before

moving to the next step. Use care not to press too

hard and damage the servo plate.

 3. Apply 2–3 drops of thin CA in each of the holes

to harden the surrounding wood. This will harden

the threads so the screws do not easily strip the

surrounding wood.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

No comments

E-flite Super Cub 25e ARF User Manual Page 27