E-flite T-34 Mentor 25e ARF User Manual download pdf (Page 6)

6 E-flite T-34 Mentor 25e ARF Assembly Manual

 11. Use a #1 Phillips screwdriver to tighten the

control horn screw. Reposition the nylon control

horn if necessary so it faces the front of the

fuselage so the rudder pushrod can be connected.

Always use threadlock on metal-to-metal fasteners

to prevent them from vibrating loose.

 12. Tighten the black screw using a #1 Phillips

screwdriver.

 13. Use a #1 Phillips screwdriver to install the two

#2 x 1/2-inch self-tapping screws that secure the

aft tail cone to the rear of the fuselage.

Radio Installation

Required Parts

Fuselage assembly Servo with hardware (2)

Receiver Y-harness

HD servo horn Hook and loop tape

Elevator pushrod wire, 23

-inch (590mm)

Rudder pushrod wire, 22

-inch (581mm)

Pushrod keeper Nylon clevis (2)

Silicone keepers (2) Plywood servo plate (2)

Radio system

Brass pushrod connector

Nylon pushrod connector backplate

Required Tools and Adhesives

Pliers Phillips screwdriver: #1

Thin CA Pin vise

Medium CA

Drill bit: 5/64-inch (2mm)

 1. Prepare the rudder and elevator servos by

installing the grommets and brass eyelets as shown.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

No comments

E-flite T-34 Mentor 25e ARF User Manual Page 6