E-flite T-34 Mentor 25e ARF User Manual download pdf (Page 16)

16 E-flite T-34 Mentor 25e ARF Assembly Manual

 9. Slide a silicone keeper on the clevis, then thread

the clevis on the linkage wire. With the aileron

servo centered, attach the clevis to a hole on the

servo horn that is 1/2-inch (13mm) from the center

of the horn. Adjust the linkage so the aileron is

aligned with the wing tip when the aileron servo is

centered.

 10. Repeat Steps 1 through 9 to install the

remaining aileron servo and linkage.

Fixed Flap Installation

Required Parts

Wing panel (left) Nylon control horn

Flap linkage Nylon clevis (2)

Silicone keeper (2) Flap stay

Required Tools and Adhesives

Medium CA

Note: If you are installing the operational

flaps you can skip this section of the manual.

 1. Thread the control horn on the flap linkage.

The top of the horn will be flush with the top of the

threads as shown.

 2. Use medium CA to attach the ﬂap stay in the

notch in the root of the right wing panel.

 3. Slide on two silicone keepers and thread the

two nylon clevises on the ﬂap linkage. Thread each

clevis 10 turns as a start.

 4. Insert the ﬂap linkage in the forward hole in the

ﬂap stay as shown.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

No comments

E-flite T-34 Mentor 25e ARF User Manual Page 16