E-flite T-34 Mentor 25e ARF User Manual download pdf (Page 19)

19E-flite T-34 Mentor 25e ARF Assembly Manual

 9. Use the ﬂap adjustment of your radio system to

set the FULL FLAP position. The measurement for

full ﬂap is 1/2-inch (13mm).

 10. Use the ﬂap adjustment of your radio system to

set the UP FLAP position. The ﬂaps will align with

the trailing edge of the wing when up.

We have shown three positions for the flaps. If you

are using a transmitter with only a 2-position switch,

then the half flap position would not be used. Flap

throws are covered at the end of the manual.

Joining the Wing Panels

Required Parts

Wing panel (right and left)

Nylon control horn Nylon strap

Aluminum wing tube

3mm x 12mm self-tapping screw (2)

Aluminum pin, 5/32 x 1

-inch (4mm x 30mm)

Required Tools and Adhesives

Thin CA Phillips screwdriver: #1

 1. Thread the control horn on the flap linkage of

the right wing. The top of the horn will be flush with

the top of the threads as shown.

 2. Slide the aluminum wing tube into the wing

panel. Slide the tube in only as far as it will easily

slide. Do not force the wing tube into the socket.

 3. Slide the 5/32 x 1

-inch (4mm x 30mm)

aluminum pin in the wing panel in the socket near

the trailing edge of the wing as shown.

 4. Slide the wing panels together. They will ﬁt

tightly together as shown in the second photo.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

E-flite T-34 Mentor 25e ARF User Manual Page 19