E-flite Rhapsody 25e ARF User Manual download pdf (Page 12)

12 E-flite Rhapsody 25e ARF Assembly Manual

 6. Slide the pushrod wire into the pushrod tube

inside the fuselage. Center the elevator servo using

the radio system. Attach the servo horn to the servo

output using the hardware provided with the servo

and a #1 Phillips screwdriver.

 7. Repeat Steps 4 though 6 to install the rudder

servo horn and the 2-56 x 19

-inch rudder

pushrod wire.

When centering the control surfaces, use a ruler or

straightedge to make sure the surface is in alignment.

 8. Slide a silicone clevis keeper on a clevis. Thread

the clevis on the pushrod wire. With the servo

centered, connect the clevis to the outer hole on the

control horn. Make sure the elevator is centered

when the clevis is connected. Slide the silicone

clevis keeper over the forks of the clevis to keep it

from opening accidentally in flight.

Drawing not to scale

Attach clevis

to outer hole

 9. Slide a silicone clevis keeper on a clevis. Thread

the clevis on the pushrod wire. With the servo

centered, connect the clevis to the outer hole on

the control horn. Make sure the rudder is centered

when the clevis is connected. Slide the silicone

clevis keeper over the forks of the clevis to keep it

from opening accidentally in flight.

Drawing not to scale

Attach clevis

to outer hole

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

E-flite Rhapsody 25e ARF User Manual Page 12