E-flite 4-Site F3P 250 ARF User Manual download pdf (Page 15)

15E-flite 4-Site Assembly Manual

 2. Use foam-safe CA to glue a carbon rod to

the control horn support as shown. Assemble

four control horns at this time.

19/32-inch

(15mm)

Cut small pieces of low-tack tape and use

them to keep the control surfaces stationary

while installing the control horns and linkages.

Make sure not to apply tape to any colored

surfaces as it will damage the trim scheme.

 3. Use a T-pin to poke a hole in the hinge tape for

each of the bottom ailerons, rudder and elevator.

 4. Use foam-safe CA to glue the control

horns in position. Make sure the control horn

supports are perpendicular to the hinge line

on each of the control surfaces.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

E-flite 4-Site F3P 250 ARF User Manual Page 15