E-flite 4-Site F3P 250 ARF User Manual download pdf (Page 10)

10 E-flite 4-Site Assembly Manual

 4. Using a square, install the 4

x 1/32-inch

(105mm x 1mm) carbon rods between the left and

right outer struts and bottom wing as shown. Make

sure to keep the bottom wing flat on your work

surface and not to deflect the outer struts between

the top and bottom wings when installing the

carbon rods.

 5. Install the remaining 4

x 1/32-inch (105mm

x 1mm) carbon rods between the left and right

outer struts and top wing as shown. Make sure to

keep the top wing flat and not to deflect the outer

struts between the top and bottom wings when

installing the carbon rods.

 6. Use foam-safe CA to install the two 5

1/32-inch (135mm x 1mm) carbon rods between

the top wing and fuselage as shown. Use care not

to induce any warps in the top wing while installing

the braces.

These two (2) rods affect the wing in many different

ways. Use caution to make sure that the wing stays

flat and is also still perpendicular to the fuselage.

 7. Check the alignment between the wings and

stabilizer. Position the stabilizer so it is parallel to

both the top and bottom wings as shown. It should

also be square to the fuselage. Check to make sure

that the wing and stabilizer are also perpendicular

to the fuselage.

Adjust stabilizer parallel to wings

Adjust perpendicular

to fuselage

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

E-flite 4-Site F3P 250 ARF User Manual Page 10