E-flite Fury 15 DF BNF Basic Instruction Manual download pdf (Page 12)

Problem Possible Cause Solution

Oscillation

Damaged rotor or spinner Replace rotoror spinner

Motor vibration Replace parts or correctly align all parts and tighten fasteners as needed

Loose receiver Align and secure receiver in fuselage

Loose aircraft controls Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)

Worn parts Replace worn parts (especially rotor, spinner or servo)

Irregular servo movement Replace servo

Inconsistent ﬂ ight

performance

Trim is not at neutral If you adjust trim more than 8 clicks, adjust the clevis to remove trim

Sub-Trim is not at neutral No Sub-Trim is allowed. Adjust the servo linkage

Aircraft was not kept immobile for

5 seconds

Power off and on the ESC while keeping the aircraft still for 5 seconds with throttle stick in lowest

position

Troubleshooting Guide AS3X

Tip: For belly landing, remove the nose gear from the fuselage.

1. Remove the 6 screws (A) and the nose cover (B) from the fuselage.

2. Loosen the set screw (C) in the steering arm (D) using a hex wrench, then

remove the arm from the nose strut (E).

3. Remove the nose strut from the cover.

4. Disconnect the nose gear linkage (F) from the innermost hole in the

steering servo arm (G).

5. Disconnect the steering servo from the servo extension in the fuselage.

CAUTION: DO NOT crush or otherwise damage wiring when attaching

the cover to the fuselage.

6. Install the nose cover on the fuselage using the 6 screws.

Nose Gear Removal

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

No comments

E-flite Fury 15 DF BNF Basic Instruction Manual Page 12