E-flite Fury 15 DF BNF Basic Instruction Manual download pdf (Page 11)

Power Component Service

CAUTION: Always disconnect the ﬂ ight battery before performing

motor service.

Disassembly

1. Remove the wing, disconnecting servos as needed.

2. Disconnect the motor connectors from the ESC connectors.

3. Remove the 4 screws (A) and fan unit (B) from the fuselage.

4. Remove the screw (C) and spinner (D) from the collet (E).

5. Remove the nut (F) rotor (G), washer (H) backplate (I) and collet from the

motor. You will need a tool to turn the nut. Tap lightly on the end of the collet

to free the backplate from the collet.

6. Remove 2 screws (J) and the motor (K) from the motor mount (L).

7. Remove 2 screws (M) and the housing (N) from the motor.

Assembly

Assemble in reverse order.

• Correctly align and connect the motor wire colors with the ESC wires.

• Ensure the front of the rotor is installed facing the nose of the aircraft.

• A tool is required to tighten the nut on the rotor and collet.

• Ensure the spinner is fully connected for safe operation.

Post Flight

Disconnect the ﬂ ight battery from the ESC (Required for Safety

and battery life).

2 Power OFF the transmitter.

3 Remove the ﬂ ight battery from the aircraft.

4 Recharge the ﬂ ight battery.

5 Repair or replace all damaged parts.

Store the ﬂ ight battery apart from the aircraft and monitor the

battery charge.

Make note of the ﬂ ight conditions and ﬂ ight plan results, planning for

future ﬂ ights.

Not all wiring shown.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

E-flite Fury 15 DF BNF Basic Instruction Manual Page 11