E-flite Apprentice S 15e RTF with SAFE User Manual download pdf (Page 5)

1. Remove the spinner, nut, washer, spinner back plate and propeller

assembly (A). Remove 3 screws (B) and the cowling (C) from the

fuselage (D). Tools are required to loosen the nut and screws.

2. Turn the model so you can see the bottom of the fuselage.

3. Under the fuselage, loosen the screw (E) in the nose gear steering arm

and insert the strut (F) (ﬂat spot facing to the front) fully in the mount (G).

4. Fully tighten the screw onto the ﬂat spot of the strut.

5. Push together the main landing gear struts (H) and insert the top loop into

the slot in the fuselage as shown.

6. Reinstall the cowling, propeller and spinner.

Disassemble in reverse order.

Landing Gear Installation

Tail Installation

Carefully support the aircraft while installing or removing screws.

TIP

1. Install the horizontal tail (A) on the fuselage under the linkages as shown.

2. Carefully insert the 2 pins (B) of the vertical ﬁn (C) through the horizontal

tail holes into the fuselage holes.

3. Under the fuselage, install the 2 screws (D) into the fuselage and the

vertical ﬁn pins. Tighten the screws, but do not break the plastic.

4. Connect the respective clevises in the outermost holes in the rudder

and elevator control horns. Refer to the clevis adjustment instructions to

center the rudder and elevators.

Disassemble in reverse order.

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

E-flite Apprentice S 15e RTF with SAFE User Manual Page 5