E-flite UMX AS3Xtra BNF Instruction Manual download pdf (Page 6)

Alternate Flight Mode Programming

Default

Flight

Mode

Alternate

Flight

Mode

Ch 5

Switch

Position

Mode Programming

Stick Positions

(Mode 2 shown)

General

Flight

Standard

AS3X

Standard

AS3X

Knife

Edge

Assist

Hover

Assist

Torque

Roll

Assist

Reset all to Default Settings

Out of the box, the AS3Xtra comes standard with 3

ﬂ ight modes, shown in bold in the chart to the right.

A transmitter with a 2-position channel 5 switch will

only allow the use of position 0 or position 2 ﬂ ight

modes.

If possible (refer to your transmitter manual) assign

channel 5 in your transmitter to a 3 position switch

to operate all 3 ﬂ ight modes. You can modify the

ﬂ ight modes available using the directions below.

NOTICE: Fast forward flight in the Hover and

Torque Roll Assist modes may cause oscillation

and damage to the aircraft.

IMPORTANT: Your transmitter must be bound to the

receiver before changing ﬂ ight mode programming.

1. Ensure all servo reversing is set to normal in

the transmitter.

2. Hold the transmitter sticks as shown, then

connect the flight battery. The assigned flight

mode switch does not need to be in a

particular position.

3. The receiver LED will flash 3 times to confirm

that the flight mode has been changed.

4. After a switch position change, fully lower the

throttle, then disconnect the flight battery. The

receiver stores the new flight mode for future

flights.

5. Repeat this process to change other flight

modes, or reset all settings to default using the

chart provided.

NOTICE: Always launch the aircraft in General Flight

or Standard AS3X

mode or damage to the aircraft

may result.

IMPORTANT: When the throttle is fully lowered for

1–2 seconds, the aircraft will reset to Standard

AS3X mode until the throttle is raised again. This is

normal. Standard AS3X mode allows you to launch

the model again without a control input being held.

Flight Mode Beneﬁ ts

Default

General

Flight

Heading hold on ailerons,

standard AS3X on elevator and

rudder.

Standard

AS3X

Standard AS3X on ailerons,

elevator and rudder.

Hover

Assistance

Aggressive heading hold on

ailerons, elevator and rudder.

Alternate

Knife Edge

Assist

Heading hold on ailerons,

elevator and rudder.

Torque Roll

Assist

Standard AS3X on ailerons,

aggressive heading hold on

elevator and rudder.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Comments to this Manuals

No comments

E-flite UMX AS3Xtra BNF Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Remote controlled toys E-flite UMX AS3Xtra BNF