E-flite UMX Radian BNF Instruction Manual download pdf (Page 9)

Flying Tips continued

Post Flight Checklist



1. Disconnect the ﬂ ight battery from the

ESC (required for safety and battery life).

2. Power OFF the transmitter.

3. Remove the ﬂ ight battery from the

aircraft.



4. Recharge the ﬂ ight battery.

5. Store the ﬂ ight battery apart from the

aircraft and monitor the battery charge.

6. Make note of the ﬂ ight conditions and

ﬂ ight plan results, planning for future

ﬂ ights.

Low Voltage Cutoﬀ (LVC)

Low Voltage Cutoﬀ (LVC) pulses the power to the

motor when the voltage gets low. When the motor

power pulses, land the aircraft immediately and

recharge the ﬂ ight battery.

Disconnect and remove the Li-Po battery from the

aircraft after use to prevent trickle discharge. Fully

charge your Li-Po battery before storing it. During

storage, make sure the battery charge does not

fall below 3V per cell.

LVC does not prevent the battery from over-

discharge during storage.

NOTICE: Repeated ﬂ ying to LVC will damage the

battery.

NOTICE: When ﬁ nished ﬂ ying, never keep the

aircraft in the sun. Do not store the aircraft in a

hot, enclosed area such as a car. Doing so can

damage the foam.

Repairs

Repair the aircraft using foam-compatible CA

glue (Cyanoacrylate adhesive) or clear tape. Only

use foam-compatible CA glue, as other types of

glue can damage the foam. When parts are not

repairable, or for a list of all replacement and

optional parts, refer to the list at the back of this

manual.

NOTICE: Use of foam-compatible CA accelerant

on your aircraft can damage paint. DO NOT handle

the aircraft until accelerant fully dries.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Comments to this Manuals

No comments

E-flite UMX Radian BNF Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Remote controlled toys E-flite UMX Radian BNF