EFLH3080E-flite® products are distributed exclusively by Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, IL 61822USA© 2009 Horizon Hobby, Inc.US p
18 1918 1912X:A. Make sure the flight battery is disconnected from the 5-in-1 unit and the transmitter is turned off.B. Move the sticks and switches
20 2120 21Control TestAlthough each Blade mSR model is test flown at the factory, it is a good idea to test the controls prior to the first flight to
22 2322 23If you decide to use an E-flite LP5DSM or HP6DSM transmitter, please position your channel reversal dip switches as follows: LP5DSM Transmi
24 2524 255-in-1 Control Unit Description, Arming and Motor Control TestThe unique 5-in-1 Control Unit installed on your Blade mSR is a lightweight co
26 2726 27powered on and that the LED indicator on the transmitter is glowing solid red. If the transmitter is powered on and functioning properly, di
28 2928 29Moving the left-hand stick to the left will turn (yaw) the nose of the helicopter to the left about the axis of the main shaft.Mode 1Mode 2N
30 3130 31Moving the aileron stick to the left will roll the helicopter to the left, allowing the helicopter to be flown sideways towards the left whe
32 3332 33Optional Training Gear InstallationIf you are transitioning from a coaxial helicopter, or you are a beginner helicopter pilot, please instal
34 3534 35Flying the Blade mSR Note: Attempting to fly the helicopter without completely reading the manual may cause injury to yourself and peopl
36 3736 37NO MATTER HOW MINOR OR MAJOR, YOU MUST LOWER THE THROTTLE STICK TO THE LOWEST POSSIBLE POSITION AS QUICKLY AS POSSIBLE TO PREVENT DAMAGE TO
2 32 3IntroductionWeighing in at under an ounce, the Blade® mSR BNF takes ultra-micro helicopter performance to the next level. Its unique Bell-Hiller
38 3938 39Troubleshooting GuideProblem Possible Cause SolutionAircraft will not “throttle up” but all other controls seem to function. •Userdidno
40 4140 41Exploded View4321795681011131512141617181921 22 232425262027Exploded View Parts ListingReference # Description (Quantity Required) Item #1
42 4342 43EFLH30025-in-1 Control Unit, Reciever, Servos, ESCs, Mixer and Gyro:BMSRTail Boom Assembly with Tail Motor, Mount and Rotor: BMSREFLH3001EFL
44 4544 45Warranty PeriodHorizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) will be free from defects in materials
46 4746 47Non-Warranty RepairsShould your repair not be covered by warranty the repair will be completed and payment will be required without notifica
48 4948 49CE Compliance Information for the European UnionInstructions for Disposal of WEEE by Users in the European UnionThis product must not be di
50 5150 51
4 54 5Additional Safety Precautions and WarningsAs the user of this product, you are solely responsible for operating it in a manner that does not end
6 76 7Preparing for First Flight RC Helicopters are not toys. We strongly suggest you follow this checklist along with the rest of the instruction ma
8 98 9 The Blade mSR’s 5-in-1 control unit features a soft low voltage cutoff (LVC) that occurs when the battery reaches 3V under load. When the sof
10 1110 11Please follow these steps to charge your single-cell Li-Po battery with the Celectra 4-port Li-Po charger.FOR PORTABLE USE:•Removethecove
12 1312 13Usage Guidelines, Warnings and Safety Precautions•Alwaysinspectbatteriesbeforecharging.•NeverchargeoruseaLi-Pobatteryorpackth
14 1514 15Installing the Flight BatteryOnce the Li-Po battery has been fully charged, it’s ready to be installed in the helicopter.Install the battery
16 1716 17Transmitter-Specific Binding InstructionsDX5e:A. Make sure the flight battery is disconnected from the 5-in-1 unit and the transmitter is t
Comments to this Manuals