E-flite UMX Pitts S-1S BNF Instruction Manual download pdf (Page 4)



1. Charge ﬂ ight battery.

2. Install ﬂ ight battery in aircraft (once it

has been fully charged).

3. Bind aircraft to transmitter.

4. Make sure linkages move freely.

5. Perform Control Direction Test with

transmitter.



6. Set dual rates and expos.

7. Adjust center of gravity.

8. Perform a radio system Range Check.

9. Find a safe and open area.

10. Plan ﬂ ight for ﬂ ying ﬁ eld conditions.

Horizon Hobby has always made RC sport, scale

and unique aircraft with the kind of performance

experts appreciate. Now the exclusive Artificial

Stability – 3 aXis (AS3X) system helps take

performance expectations in ultra micro aircraft a

quantum leap higher.

Based on the successful use of MEMS sensor

technology within the AS3X Stabilization System

essential to Blade

ultra micro flybarless

helicopters, the specifically tuned AS3X System

for airplanes helps invisibly correct for turbulence,

torque and tip stalls when encountered.

Furthermore, the outstanding control agility delivers

an ultra smooth, locked-in feel that obeys your

every command with performance that’s natural

feeling. It’s so gratifying, in fact, that it’s as though

you’re the RC pilot of an expertly tuned, giant-scale

model.

AS3X will change the way you’ll want to fly now and

in the future. To see what we mean, go to

www.E-fliteRC.com/AS3X.

Preﬂ ight Checklist

AS3X Stabilization Delivers Breakthrough Performance

When a Li-Po battery is discharged below 3V per

cell, it will not hold a charge. The aircraft’s ESC

protects the ﬂ ight battery from over-discharge

using Low Voltage Cutoff (LVC). Once the battery

discharges to 3V per cell, the LVC will reduce the

power to the motor in order to leave adequate

power to the receiver and servos to land the

airplane.

When the motor power decreases, land the aircraft

immediately and replace or recharge the ﬂ ight

battery.

Always disconnect and remove the Li-Po battery

from the aircraft after each ﬂ ight. Charge your Li-Po

battery to about half capacity before storage. Make

sure the battery charge does not fall below 3V per

cell. Failure to unplug a connected battery will result

in trickle discharge.

For your ﬁ rst ﬂ ights, set your transmitter timer or a

stopwatch to 5 minutes. Adjust your timer for longer

or shorter ﬂ ights once you have ﬂ own the model.

NOTICE: Repeated ﬂ ying to LVC will damage the

battery.

Low Voltage Cutoff (LVC)

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

E-flite UMX Pitts S-1S BNF Instruction Manual Page 4

Comments to this Manuals

Related products and manuals for Remote controlled toys E-flite UMX Pitts S-1S BNF