E-flite Carbon-Z Yak 54 3X Instruction Manual download pdf (Page 13)

Transmitter Setup

Transmitter Setup Checklist

Before binding for Computerized Transmitters (DX6i, DX7/DX7se,

DX7s, DX8, DX9, DX10t, DX18):

1. Choose a blank model memory.

2. Choose Wing/Aircraft Type for single aileron servo.

3. Set all trim and sub-trims to NEUTRAL (0%).

4. Set servo travel values to the recommended settings.

5. Set the Dual Rate value according to the Dual Rate and Expo

chart.

After binding:

1. DO NOT use sub-trims to make ﬁ ne adjustments. Off-center

subtrim will affect servo travel and AS3X operation.

2. Adjust linkage lengths so the control surfaces center when the

servo arm is close to perpendicular

CAUTION: For safe operation, always re-bind the airplane after

setup is complete to ensure the failsafe is updated with the latest

setup.

IMPORTANT: The AR635 receiver’s default setting in this aircraft is normal

mode. We recommend that you do not change this setup. Refer to the receiver

manual for more information.

A programmable DSM2/DSMX six-channel (or better) transmitter with Dual

Rates is required for ﬂ ying this aircraft. The Spektrum

™

DX6i, DX7s, DX8, DX9,

DX10t, DX18 and JR

X9503, 11X or 12X transmitters may be used.

Below are the recommended settings for Servo Travel.

Throttle 100%

Aileron 125%

Elevator 125%

Rudder 125%

Channel 5 100%

Dual Rates and Expos

Adjust rate and expo to the recommended values shown in the chart.

NOTICE: To ensure AS3X functions properly, do not lower rate values below

50%. If lower rates are desired, manually adjust the position of the pushrods

on the servo arm.

NOTICE: If oscillation occurs at high speed, refer to the Troubleshooting Guide

for more information.

Dual Rate High Rate

Expo

Low Rate

Expo

Aileron

70mm /

10%

37mm /

45%

Elevator

75mm /

10%

19mm /

40%

Rudder

110mm /

10%

65mm /

40%

Preﬂ ight Preparation

1. Remove and inspect contents.

2. Charge ﬂ ight battery.

3. Read this instruction manual thoroughly.

4. Fully assemble airplanes.

5. Install the ﬂ ight battery in the aircraft (once it has been fully charged).

6. Check the Center of Gravity (CG)

7. Bind aircraft to your transmitter.

8. Make sure linkages move freely.

9. Perform the Control Direction Test with the transmitter.

10. Perform the AS3X Control Direction Test with the aircraft.

11. Adjust ﬂ ight controls and transmitter.

12. Perform a radio system Range Check.

13. Find a safe and open area.

14. Plan ﬂ ight for ﬂ ying ﬁ eld conditions.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Comments to this Manuals

No comments

E-flite Carbon-Z Yak 54 3X Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Remote controlled toys E-flite Carbon-Z Yak 54 3X