E-flite Leader 480 User Manual download pdf (Page 7)

7E-flite Leader 480 ARF Assembly Manual

 4. Connect a 6-inch (152mm) servo extension to the

servo lead. Use string of dental floss to secure the

leads so they do not accidentally disconnect inside

the wing. Use a #0 Phillips screwdriver to remove the

servo horn from the servo.

 5. Insert the servo lead into the wing. Tip the wing

tip up and guide the lead out of the wing at the

wing root.

 6. Use a T-pin to puncture the covering, locating the

openings for the servo mounting screws.

 7. Use a #1 Phillips screwdriver to thread a servo

mounting screw into each of the holes to cut threads

in the surrounding wood. Remove the screw before

moving to the next step.

 8. Apply 2–3 drops of thin CA in each of the holes

to harden the surrounding wood. This will harden

the threads so the screws do not easily strip the

surrounding wood.

 9. Secure the servo in the wing using the screws

provided with the servo and a #1 Phillips screwdriver.

The output shaft of the servo faces toward the aileron

as shown. Center the aileron servo using the radio

system. Attach the servo horn prepared in step 3

using the screw removed in step 4 and a #0 Phillips

screwdriver. Note that the servo horn is parallel to the

aileron hinge line.

Note: It may be necessary to trim the servo

opening for the servo used.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

No comments

E-flite Leader 480 User Manual Page 7