E-flite S.E.5a Slow Flyer 250 ARF User Manual

Browse online or download User Manual for Air equipment E-flite S.E.5a Slow Flyer 250 ARF. E-flite S.E.5a Slow Flyer 250 ARF User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Specifications
Wingspan: 30 in (760mm)
Length: 23 in (595mm)
Wing Area: 310 sq in (20.0 sq dm)
Weight w/battery: 7.5–8.5 oz (210–225 g)
Weight w/o battery: 7 oz (200 g)
Radio: 3-channels with 2 sub-micro servos
S.E.5a Slow Flyer ARF
Assembly Manual
Page view 0
1 2 3 4 5 6 ... 31 32

Summary of Contents

Page 1 - S.E.5a Slow Flyer ARF

SpecificationsWingspan: 30 in (760mm)Length: 23 in (595mm)Wing Area: 310 sq in (20.0 sq dm)Weight w/battery: 7.5–8.5 oz (210–225 g)Weight w/o batt

Page 2 - Table of Contents

10 E-flite S.E.5a Slow Flyer ARF Assembly Manual 7. Position the motor so is does not rub against the cowl. Apply a few drops of foam-safe CA to the

Page 3 - Required Radio Equipment

11E-flite S.E.5a Slow Flyer ARF Assembly Manual 11. Turn on your radio system and select a new model if using a computer radio. Make sure all the su

Page 4

12 E-flite S.E.5a Slow Flyer ARF Assembly Manual 14. Use double-sided tape to secure the receiver inside the fuselage. Position the antenna wires

Page 5 - Safety Precautions

13E-flite S.E.5a Slow Flyer ARF Assembly ManualImportant Information About Your Brushless ESCMake sure your ESC brake is programmed to Off. Also, be s

Page 6 - Non-Warranty Repairs

14 E-flite S.E.5a Slow Flyer ARF Assembly Manual 2. Position and center the bottom wing on the fuselage. Use a felt-tipped pen to mark the locatio

Page 7 - Motor Installation

15E-flite S.E.5a Slow Flyer ARF Assembly Manual 5. Using a ruler, check the alignment of the bottom wing to the fuselage. The distance from each win

Page 8

16 E-flite S.E.5a Slow Flyer ARF Assembly Manual 9. Position the outer strut between the top and bottom wings as shown. Use foam-safe CA to glue the

Page 9

17E-flite S.E.5a Slow Flyer ARF Assembly Manual  2. Slide a micro control horn into the slot in the rudder as shown. Note that the rudder control h

Page 10

18 E-flite S.E.5a Slow Flyer ARF Assembly Manual 5. Position the tail onto the fuselage and check that they rest parallel to the top and bottom wing

Page 11

19E-flite S.E.5a Slow Flyer ARF Assembly Manual 2. Slide the pushrod wire into the pushrod tube located in front of the elevator control horn. 3.

Page 12

2 E-flite S.E.5a Slow Flyer ARF Assembly ManualIntroductionThe S.E.5a was a fast, maneuverable WWI fighter plane. Together with the Sopwith Camel, the

Page 13 - Wing Installation

20 E-flite S.E.5a Slow Flyer ARF Assembly Manual 5. With the elevator centered, use a 2mm x 4mm machine screw in the connector and a #0 Phillips scr

Page 14

21E-flite S.E.5a Slow Flyer ARF Assembly ManualLanding Gear InstallationRequired Parts• Airframe • Landing gear• Wheel (2) • Wheel retainer (2)Requi

Page 15

22 E-flite S.E.5a Slow Flyer ARF Assembly Manual 4. Carefully press the gear into the slots at the front and rear into the fuselage.Note: You may put

Page 16 - Attach the Fin and Stabilizer

23E-flite S.E.5a Slow Flyer ARF Assembly Manual 1. Cut an 80-inch (2000mm) piece of the rigging line.Pass the rigging line through the lower front h

Page 17

24 E-flite S.E.5a Slow Flyer ARF Assembly Manual 5. The rigging then will go from the front lower hole to the upper rear hole, crossing the outer st

Page 18 - Radio Installation

25E-flite S.E.5a Slow Flyer ARF Assembly Manual 9. Apply light tension on all the rigging at this time. Use foam-safe CA to glue the end of the rigg

Page 19

26 E-flite S.E.5a Slow Flyer ARF Assembly Manual 13. Cross the rigging between the cabane struts. 14. The rigging is then routed to the lower rear

Page 20

27E-flite S.E.5a Slow Flyer ARF Assembly Manual 17. From the fuselage, run the rigging up to the upper front hole in the outer strut. 18. Apply li

Page 21 - Landing Gear Installation

28 E-flite S.E.5a Slow Flyer ARF Assembly ManualMachine Gun Installation Required PartsCompleted airframeMachine gunRequired Tools and AdhesivesFoam-s

Page 22 - Wing Rigging Installation

29E-flite S.E.5a Slow Flyer ARF Assembly ManualCenter of GravityAn important part of preparing the aircraft for flight is properly balancing the model

Page 23

3E-flite S.E.5a Slow Flyer ARF Assembly ManualContents of Kit/Parts LayoutLarge Replacement PartsEFL1926 Wing (Top and Bottom)EFL1927 FuselageEFL192

Page 24

30 E-flite S.E.5a Slow Flyer ARF Assembly ManualPreflightCheck Your RadioBefore going to the field, be sure that your batteries are fully charged per

Page 25

31E-flite S.E.5a Slow Flyer ARF Assembly Manual2007 Official AMA National Model Aircraft Safety CodeGENERAL1) I will not fly my model aircraft in sa

Page 26

11036© 2007 Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, Illinois 61822 (877) 504-0233 horizonhobby.com E-fliteRC.com

Page 27

4 E-flite S.E.5a Slow Flyer ARF Assembly ManualMotor SetupEFLM1130 Park 250 Outrunner, 2200KvEFLA1010 10A Brushless ESCEFLB4302SJ 430mAh 2-Cell 7.4

Page 28 - Control Throws

5E-flite S.E.5a Slow Flyer ARF Assembly ManualLimited Warranty(a) This warranty is limited to the original Purchaser ("Purchaser") and is no

Page 29 - Range Test Your Radio

6 E-flite S.E.5a Slow Flyer ARF Assembly ManualQuestions, Assistance, and RepairsYour local hobby store and/or place of purchase cannot provide warran

Page 30 - Flying the S.E.5a Slow Flyer

7E-flite S.E.5a Slow Flyer ARF Assembly ManualSafety, Precautions, and WarningsAs the user of this product, you are solely responsible for operating i

Page 31 - Model Aircraft Safety Code

8 E-flite S.E.5a Slow Flyer ARF Assembly Manual8 E-flite S.E.5a Slow Flyer ARF Assembly Manual 2. Attach the speed control inside the fuselage using

Page 32 - E-fliteRC.com

9E-flite S.E.5a Slow Flyer ARF Assembly Manual 9E-flite S.E.5a Slow Flyer ARF Assembly Manual 5. Slide the motor assembly into the fuselage. Plug th

Comments to this Manuals

No comments